Oil Pulling And Candida

Raising a

Salve all!

in this post illustrate some of the process by which the front shield umbo was created

is not so much a tutorial, as there are many photos, nor are as epic moments of hammering metal to red ... but is more or less as it was progressing the matter.


well, starting this work required of 2 essential tools, a stick, ball and hammer flat-blade rounded (formerly would have required about three types of cuttings and a much bigger hammer, plus a heat source over pig torch intense than we use, but we did not xD)

Work began putting the stake on the anvil, by heating with the torch until it could be some red (the idea would strike when the orange glow almost white ... but anyway xD). G said the torch and the metal and hit me, or sometimes we traded jobs. The point is that the first thing we were closer to a geographical than a piece of shield.

see that looks like a mountain? xD
at this point we were somewhat discouraged, so much work for just that ... (We had a good time to do that, maybe a couple of hours). and there denuevo started from the tip hitting much on the edge of the stake, there began to be little change, and again after a fairly long time was something like this:



beginning to be felt the way it should have, although much still remains, and the more we advance the metal becomes more and more hard work, it wrinkles terribly and need to straighten it with care muuucho risk of losing the entire piece.

we continue working in and moving more
must note one thing, as this will only work at the stake for a small problem arose ball and the ball was, by hammering the metal segment tracking to lift (Raise) also stood up and anterior segment
and that curve toward the umbo be made unless pronounced.


After this I have more pictures of the intermediate process and all the plaster that had to do (because by God that require flat Raising the pieces after the flat well we did on the peg ball, the other party (and polished) of the hammer.

the point is that after all, matching the edges with the anvil and everything else, was something like:

there just need to cut the leftovers, puncture and put on the coat
was all over xD. (there is very noticeable loss of depth would be needed to prevent that from working on a stake in "T") and



believe that the moral of this story is that if you want to do raising, the better you get an oxyacetylene torch or a furnace, for if not ....

that's all for now
almost goes without saying that all the example of the raising was done with the videos of Erik Dube, would not be of more youtube: P

and Eid Greetings to